OEM Closed Loop Stepper Motor
Controller/Driver with CANopen®
(QCI-D2-MG-C)
9 June 2008
QCI-D2-MG-C1 |
QCI-D2-MG-C |
QuickSilver has added a CANopen® option to its smallest (2”/52mm x 2.5”/63mm) most cost effective closed loop stepper motor controller. CANopen can be configured for peer-to-peer, master or slave which allows the controllers to share I/O and registers with other CANopen enabled SilverDust controllers or 3rd party CANopen devices (i.e. I/O blocks, encoders, PLCs…). For a multi-axis system, connect several MG-Cs, make one the master and let the others receive motion commands over CANopen.
This single axis, programmable controller/driver is specially designed to servo 3rd party stepper motors creating a closed loop stepper system, or, in other words, a servo system using a stepper motor. It also includes serial communications (RS-232, RS-485), and 7 I/O. The RS-232/RS-485 serial network runs independently in parallel to CAN for supervisory control from a host (i.e. PC, PLC, HMI..).
The 7 bi-directional I/O, 12V-48V input power, and communications signals are accessed through the DB15HD port and can be separated using one of our popular breakouts (QCI-BO-B, QCI-BO-B1, QCI-BO-B1A).
Other MG-C Features:
- 12-48V DC Input Power (UL CE)
- 7 TTL, Bi-Directional I/O
For 24V use QCI-BO-B52 - 4 Analog Inputs
- Non-Volatile Memory
- ~3000 program lines
- R2-232/485(ASCII, Modbus® RTU)
- 3.5A Continuous/4.5A Peak
- CANopen
- 100:1 Inertial Miss-Match
- PVIA™ Servo Loop
- Point To Point Moves
- Profile Moves
- Electronic Gearing/Camming
- Multiple Thread Programming
Get High Resolution Picture QCI-D2-MG-C (6x6 300DPI)
Get High Resolution Picture QCI-D2-MG-C1 (6x6 300DPI)
CANopen® and CiA® are registered community trade marks of CAN in Automation e.V.